«

»

May 30

Sealing the back of your headlights

I'm a little stumped on how I'm going to seal up the back of my headlights after fitting the projectors into the reflectors. My headlight has to doors on the rear, one for signal lights and one for the main 9007/4 bulb. The rear of the projector ends up in a bad spot(see picture below) so I'm looking at having to cut a big 'ol hole to make it all work. Now I can use some plastic to make a new rear housing, with a spot for the ignitor to peak through as well as the headlight harness connector to plug into. But how do I seal it all up to keep water out?

Sent from my SM-N910T using Tapatalk